Sanisplit specification & selection guide

• Use the chart above to select the correct unit for your application.
• Units 1-3 only; are suitable for WC waste, note the large outlets on the drawings below.
• Units K2 + K3 are pumping units suitable for waste water only.

Note that the top 40mm outlet at the rear of the unit is the main waste, which needs to be taken to the soil stack, the remainder are inlets from the appliances or sanitary ware. These inlets can be plugged if not required.

See pipe run drawings in the ' ability to remove the waste products whilst keeping the pipe runs as aesthetically pleasing as possible' section for further detail.

• SANISPLIT requires a 230 v ac 50Hz single phase supply (U.K. specifications).
• The appliance must not be connected to a conventional plug & socket.
• SANISPLIT must be wired into a fused unswitched fixed wiring connector fitted with a 5A fuse.
• SANISPLIT is double insulated and has earth connections.